Once that the OS booted, I tried to see if the webcam was recognized: ls -ltrh /dev/video* I found some useful informations on the Sunxi website. I removed the micro USB breakout board and put some pin headers:ĪRMBIAN 5.38 stable Ubuntu 16.04.4 LTS 4.14.18-sunxi I chose to use the USB-DM2 / USB-DP2 as they are close to 5V and GND pins. We can see that 2 USB port pins are available (USB-Dx2 / USB-Dx3). Connect the webcam to the Orange Pi Zero HardwareĪs the only USB port socket on the Orange PI Zero is used by the 3D printer, I looked at the Orange PI Zero pinout: The webcam is an UVC compatible device, which is a good news as it supported by Linux. It seems that the module is just connected through an USB interface !Īnd it works! No driver to install to get it work with Windows 10. The chip on the module is an Etron eSP268.Īnd 4 wires are connected to the module (red / black / blue / white). I found a little module with a camera on it, and I asked myself if it could be reused. I recently dismantled an old Android 2.2 notebook before throwing it away (based on the Wondermedia WM8650). I'm using the basic Orange Pi Zero with 512Mo RAM Webcam module Remark: when I wrote this article, I discovered that new editions of the Orange Pi Zero exists (Plus / Plus2 H3, H5.). The best guide I found is the one from deloarts. In a previous blog entry, I explained (in French) that I added Octoprint to my Dagoma DiscoEasy200 thanks to an Orange Pi Zero.
0 Comments
Leave a Reply. |